F-tile Architecture and PMA and FEC Direct PHY IP User Guide

ID 683872
Date 12/15/2021
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.8.1. Reset Signal Requirements

The following requirements apply to reset signal use for F-tile PMA/FEC Direct PHY designs:
  • Ensure that tx_reset/rx_reset remain asserted until tx_reset_ack/rx_reset_ack goes high.
  • Expect random data if tx_ready/rx_ready is not asserted.
  • In forward error correction (FEC) modes, during reset sequencing, after tx_am_gen_start is asserted, start sending alignment markers and assert tx_am_gen_2x_ack after two alignment markers are sent. tx_am_gen_start goes high as part of reset sequence (that is, before tx_ready is asserted).
  • In FEC modes when sending alignment markers, you can pace tx data valid with the tx_cadence signal.
  • For duplex configurations, you can assert tx_reset and rx_reset independently.

Did you find the information on this page useful?

Characters remaining:

Feedback Message