1. Introduction to the Intel® Agilex™ Device Design Guidelines 2. System Specification 3. Device Selection 4. Security Considerations 5. Design Entry 6. Board and Software Considerations 7. Design Implementation, Analysis, Optimization, and Verification 8. Debugging 9. Embedded Software Design Guidelines for Intel® Agilex™ SoC FPGAs
5.1.1. Firewall Planning 5.1.2. Boot And Configuration Considerations 5.1.3. HPS Clocking and Reset Design Considerations 5.1.4. Reset Configuration 5.1.5. HPS Pin Multiplexing Design Considerations 5.1.6. HPS I/O Settings: Constraints and Drive Strengths 5.1.7. Design Guidelines for HPS Interfaces 5.1.8. Interfacing between the FPGA and HPS 5.1.9. Implementing the Intel® Agilex™ HPS Component
7.1. Selecting a Synthesis Tool 7.2. Device Resource Utilization Reports 7.3. Intel® Quartus® Prime Messages 7.4. Timing Constraints and Analysis 7.5. Area and Timing Optimization 7.6. Preserving Performance and Reducing Compilation Time 7.7. Designing with Intel® Hyperflex™ 7.8. Simulation 7.9. Power Analysis 7.10. Power Optimization 7.11. Design Implementation, Analysis, Optimization, and Verification Revision History
9.1. Overview 9.2. Golden Hardware Reference Design (GHRD) 9.3. Define Software Requirements 9.4. Define Software Architecture 9.5. Selecting Software Tools 9.6. Choosing the Bootloader Software 9.7. Selecting an Operating System for Your Application 9.8. Assembling Your Software Development Platform for Linux* 9.9. Assembling your Software Development Platform for Partner OS or RTOS 9.10. Driver Considerations 9.11. Boot And Configuration Considerations 9.12. System Reset Considerations 9.13. Flash Considerations 9.14. Develop Application 9.15. Test and Validate 9.16. Embedded Software Design Guidelines Revision History
6.2.1. Boundary Scan for HPS
The HPS JTAG interface does not support boundary scan tests (BST). To perform boundary scan testing on HPS I/Os, you must first chain the FPGA JTAG and HPS JTAG internally, and issue the boundary scan from the FPGA JTAG.
GUIDELINE: Chain the FPGA and HPS JTAG interfaces internally to perform boundary scan testing.
To chain the FPGA and HPS JTAG internally, go to Quartus Device and Pins Options and select the Configuration category. Under the HPS debug access port (DAP) settings, choose SDM Pins from the drop down option. If boundary scan is not being used, the FPGA JTAG and HPS JTAG interfaces can be used independently. To select HPS Dedicated I/O as the interface for HPS JTAG, select HPS Pins from the drop down option instead.
Did you find the information on this page useful?