126.96.36.199.1. Non-Bonded Channel Configurations Using the x1 Clock Network 188.8.131.52.2. Non-Bonded Channel Configurations Using the xN Clock Network 184.108.40.206.3. Bonded Channel Configurations 220.127.116.11.4. Bonded Channel Configurations Using the xN Clock Network 18.104.22.168.5. Bonded Channel Configurations Using the PLL Feedback Compensation Path
3.2.1. User-Coded Reset Controller Signals 3.2.2. Resetting the Transmitter with the User-Coded Reset Controller During Device Power-Up 3.2.3. Resetting the Transmitter with the User-Coded Reset Controller During Device Operation 3.2.4. Resetting the Receiver with the User-Coded Reset Controller During Device Power-Up Configuration 3.2.5. Resetting the Receiver with the User-Coded Reset Controller During Device Operation
4.1. Protocols and Transceiver PHY IP Support 4.2. 10GBASE-R and 10GBASE-KR 4.3. Interlaken 4.4. PCI Express (PCIe)—Gen1, Gen2, and Gen3 4.5. XAUI 4.6. CPRI and OBSAI—Deterministic Latency Protocols 4.7. Transceiver Configurations 4.8. Native PHY IP Configuration 4.9. Stratix V GT Device Configurations 4.10. Document Revision History
4.2.1. 10GBASE-R and 10GBASE-KR Transceiver Datapath Configuration 4.2.2. 10GBASE-R and 10GBASE-KR Supported Features 4.2.3. 1000BASE-X and 1000BASE-KX Transceiver Datapath 4.2.4. 1000BASE-X and 1000BASE-KX Supported Features 4.2.5. Synchronization State Machine Parameters in 1000BASE-X and 1000BASE-KX Configurations 4.2.6. Transceiver Clocking in 10GBASE-R, 10GBASE-KR, 1000BASE-X, and 1000BASE-KX Configurations
4.4.1. Transceiver Datapath Configuration 4.4.2. Supported Features for PCIe Configurations 4.4.3. Supported Features for PCIe Gen3 4.4.4. Transceiver Clocking and Channel Placement Guidelines 4.4.5. Advanced Channel Placement Guidelines for PIPE Configurations 4.4.6. Transceiver Clocking for PCIe Gen3
6.1. Dynamic Reconfiguration Features 6.2. Offset Cancellation 6.3. PMA Analog Controls Reconfiguration 6.4. On-Chip Signal Quality Monitoring (Eye Viewer) 6.5. Decision Feedback Equalization 6.6. Adaptive Equalization 6.7. Dynamic Reconfiguration of Loopback Modes 6.8. Transceiver PLL Reconfiguration 6.9. Transceiver Channel Reconfiguration 6.10. Transceiver Interface Reconfiguration 6.11. Document Revision History
22.214.171.124. Dedicated refclk Pins Using the Reference Clock Network
Each dedicated refclk pin can drive any transmitter PLL on the same side of the device through the reference clock network. Designs using multiple transmitter PLLs that require the same reference clock frequency and are located along the same side of the device can share the same dedicated refclk pin.
Did you find the information on this page useful?