Video and Vision Processing Suite IP User Guide

ID 683329
Date 3/30/2025
Public
Document Table of Contents
1. About the Video and Vision Processing Suite 2. Getting Started with the Video and Vision Processing IPs 3. Video and Vision Processing IPs Functional Description 4. Video and Vision Processing IP Interfaces 5. Video and Vision Processing IP Registers 6. Video and Vision Processing IPs Software Programming Model 7. Protocol Converter IP 8. 1D LUT IP 9. 3D LUT IP 10. Adaptive Noise Reduction IP 11. Advanced Test Pattern Generator IP 12. AXI-Stream Broadcaster IP 13. Bits per Color Sample Adapter IP 14. Black Level Correction IP 15. Black Level Statistics IP 16. Chroma Key IP 17. Chroma Resampler IP 18. Clipper IP 19. Clocked Video Input IP 20. Clocked Video to Full-Raster Converter IP 21. Clocked Video Output IP 22. Color Plane Manager IP 23. Color Space Converter IP 24. Defective Pixel Correction IP 25. Deinterlacer IP 26. Demosaic IP 27. FIR Filter IP 28. Frame Cleaner IP 29. Full-Raster to Clocked Video Converter IP 30. Full-Raster to Streaming Converter IP 31. Genlock Controller IP 32. Generic Crosspoint IP 33. Genlock Signal Router IP 34. Guard Bands IP 35. Histogram Statistics IP 36. Interlacer IP 37. Mixer IP 38. Pixels in Parallel Converter IP 39. Scaler IP 40. Stream Cleaner IP 41. Switch IP 42. Text Box IP 43. Tone Mapping Operator IP 44. Test Pattern Generator IP 45. Unsharp Mask IP 46. Video and Vision Monitor Intel FPGA IP 47. Video Frame Buffer IP 48. Video Frame Reader Intel FPGA IP 49. Video Frame Writer Intel FPGA IP 50. Video Streaming FIFO IP 51. Video Timing Generator IP 52. Vignette Correction IP 53. Warp IP 54. White Balance Correction IP 55. White Balance Statistics IP 56. Design Security 57. Document Revision History for Video and Vision Processing Suite User Guide

30.3. Full-Raster to Streaming Converter Block Description

The IP accepts full-raster video input format as a full-raster interface of pixel data and timing markers embedded in the TDATA bus of an AXI4-S interface. Also, the IP filters out the timing markers from the TDATA bus and provides a video-active only data format on the output interfaces that conforms to the Intel FPGA streaming video protocol specification.
Figure 93. Full-Raster to Streaming Converter high-level block diagram.The figure shows the IP consists of two blocks: a full-raster stripper and an asynchronous FIFO buffer.

The full-raster stripper strips the full-raster timing information from the AXI4-S full-raster stream, leaving active-video data on the AXI4-S lite bus. The IP strips the timing information by setting the AXI4-S TVALID signal low during the blanking interval. When the input AXI4-S full-raster bus sets its TUSER signal high, the IP is in blanking. The stripper holds the TUSER high until the IP transmits the first active pixel.

Figure 94. Full-Raster to Streaming Converter Timing DiagramAn example of how the output TUSER signal is generated by detecting and holding the input TUSER signal on the full-raster video domain, until the first active pixel is detected on the TDATA bus.

The full-raster stripper has a pixel formatter logic, which is mainly based on a barrel shifter logic. It allows the IP to detect the correct position of the start of field for a pixel in parallel scenarios. It aligns the tdata packet content on the output video stream to ensure that the start of field always coincides with pixel 0.

The IP assumes that the transmitter side generates video data with a slower or faster pixel clock rate compared to the receiver video interface. Consequently, moving video data between two different clock domains requires clock domain crossings. Additionally, the TVALID and TREADY flow-controlled AXI4-S video interface may cause the following control-flow problems on the video datapath:

  • Clock-skew matching, if video receiver and transmitter and video processing clocks do not match.
  • In-rush of data if one of the modules in the video pipeline cannot offer the necessary throughput to move the data at the expected rate.

This IP includes an asynchronous output FIFO buffer that handles clock crossing domains between the full-raster and video processing clock domains. Additionally, it temporally accepts data to accommodate a small amount of data-skew mismatching or in-rush data when transferring data between full-raster and active-video only video interfaces.