HDMI Intel® FPGA IP User Guide

ID 683798
Date 4/22/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

4.3.3.1. Set Up the Hardware

The first stage of the demonstration is to set up the hardware.

To set up the hardware for the demonstration:

  1. Connect the Bitec HDMI HSMC 2.0 daughter card to the FPGA development board.
  2. Connect the FPGA board to your PC using a USB cable.
    Note: The Arria V GX FPGA Starter Kit and Stratix V GX FPGA Development Kit have an On-Board Intel® FPGA Download Cable II connector. If your version of the board does not have this connector, you can use an external Intel® FPGA Download Cable cable.
  3. Connect an HDMI cable from the HDMI RX connector on the Bitec HDMI HSMC 2.0 daughter card to a standard HDMI source, in this case a PC with a graphic card and HDMI output.
  4. Connect another HDMI cable from the HDMI TX connector on the Bitec HDMI HSMC 2.0 daughter card to a standard HDMI sink, in this case a monitor with HDMI input.

Did you find the information on this page useful?

Characters remaining:

Feedback Message