Stratix® 10 Hard Processor System Technical Reference Manual

ID 683222
Date 8/15/2024
Public
Document Table of Contents

15.5.2.2.1. Unlocking a Span of Memory Blocks

To unlock several blocks of memory, perform the following steps:
  1. Write to the command register, setting the CMD_MAP field to 2 and the BLK_ADDR field to the starting address of the area to unlock.
  2. Write 0x10 to the Data register.
  3. Write to the command register, setting the CMD_MAP field to 2 and the BLK_ADDR field to the ending address of the area to unlock.
  4. Write 0x11 to the Data register.

When unlocking a range of blocks, the start block address must be less than the end block address. Otherwise, the NAND flash controller exhibits undetermined behavior.