E-tile Hard IP User Guide: E-Tile Hard IP for Ethernet and E-Tile CPRI PHY Intel® FPGA IPs

ID 683468
Date 12/13/2021
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

2.9.2.4. PTP Receive Functionality

If you turn on Enable IEEE 1588 PTP in the E-Tile Hard IP for Ethernet Intel FPGA IP parameter editor, the IP core provides a 96-bit (V2 format) with every packet on the RX client interface, whether it is a 1588 PTP packet or not. The value on the timestamp bus o_ptp_rx_its is valid in the same clock cycle as the RX SOP signal. The value on the timestamp bus is not the current timestamp; instead, it is the timestamp from the time when the IP core received the packet on the Ethernet link. The IP core captures the time-of-day from the TOD module on i_ptp_tod at the time it receives the packet on the Ethernet link, and sends that timestamp to the client on the RX SOP cycle on the timestamp bus o_ptp_rx_its. User software/hardware logic can use this timestamp or ignore it based on whether it is a 1588 PTP packet or not.

The RX PTP operation assumes the o_sl_rx_ptp_ready signal was asserted and is held high.

Figure 28. PTP Receive Block Diagram
Figure 29. Example Waveform PTP Timestamp on RX PTP Interface