Agilex™ 7 FPGAs and SoCs Device Data Sheet: F-Series and I-Series

Download PDF
ID 683301
Date 8/29/2025
Public
Document Table of Contents
Document Table of Contents x
Agilex™ 7 FPGAs and SoCs Device Data Sheet: F-Series and I-Series
Agilex™ 7 FPGAs and SoCs Device Data Sheet: F-Series and I-Series x
Electrical Characteristics Switching Characteristics Configuration Specifications I/O Timing Programmable IOE Delay Glossary Document Revision History for the Agilex 7 FPGAs and SoCs Device Data Sheet: F-Series and I-Series
Electrical Characteristics x
Operating Conditions
Operating Conditions x
Absolute Maximum Ratings Maximum Allowed Overshoot and Undershoot Voltage Recommended Operating Conditions DC Characteristics I/O Standard Specifications
Recommended Operating Conditions x
Recommended Operating Conditions E-Tile Transceiver Power Supply Recommended Operating Conditions P-Tile Transceiver Power Supply Recommended Operating Conditions R-Tile Transceiver Power Supply Recommended Operating Conditions F-Tile Transceiver Power Supply Recommended Operating Conditions HPS Power Supply Recommended Operating Conditions
DC Characteristics x
Supply Current and Power Consumption I/O Pin Leakage Current Bus Hold Specifications OCT Calibration Accuracy Specifications OCT Without Calibration Resistance Tolerance Specifications Pin Capacitance Internal Weak Pull-Up Resistor Hysteresis Specifications for Schmitt Trigger Input
I/O Standard Specifications x
Single-Ended I/O Standards Specifications Single-Ended SSTL, HSTL, HSUL, and POD I/O Reference Voltage Specifications Single-Ended SSTL, HSTL, HSUL, and POD I/O Standards Signal Specifications Differential SSTL, HSTL, and HSUL I/O Standards Specifications Differential POD I/O Standards Specifications Differential I/O Standards Specifications
Switching Characteristics x
Core Performance Specifications Periphery Performance Specifications E-Tile Transceiver Performance Specifications P-Tile Transceiver Performance Specifications R-Tile Transceiver Performance Specifications F-Tile Transceiver Performance Specifications HPS Performance Specifications
Core Performance Specifications x
Clock Tree Specifications I/O PLL Specifications DSP Block Specifications Memory Block Specifications Local Temperature Sensor Specifications Remote Temperature Diode Specifications Voltage Sensor Specifications
Periphery Performance Specifications x
LVDS SERDES Specifications DPA Lock Time Specifications LVDS SERDES Soft-CDR Sinusoidal Jitter Tolerance Specifications Memory Standards Supported DLL Range Specifications Memory Output Clock Jitter Specifications
E-Tile Transceiver Performance Specifications x
E-Tile Transceiver Performance E-Tile Transceiver Reference Clock Specifications E-Tile Transmitter Specifications E-Tile Receiver Specifications
P-Tile Transceiver Performance Specifications x
P-Tile Transceiver Performance P-Tile Transceiver Reference Clock Specifications P-Tile Transmitter Specifications P-Tile Receiver Specifications
R-Tile Transceiver Performance Specifications x
R-Tile Transceiver Performance R-Tile Transceiver Reference Clock Specifications R-Tile Transmitter Specifications R-Tile Receiver Specifications
F-Tile Transceiver Performance Specifications x
F-Tile Transceiver Performance F-Tile Transceiver Reference Clock Specifications F-Tile Transmitter Specifications F-Tile Receiver Specifications F-Tile Electrical Compliance
HPS Performance Specifications x
HPS Clock Performance HPS Internal Oscillator Frequency HPS PLL Specifications HPS Cold Reset HPS SPI Timing Characteristics HPS SD/MMC Timing Characteristics HPS USB UPLI Timing Characteristics HPS Ethernet Media Access Controller (EMAC) Timing Characteristics HPS I2C Timing Characteristics HPS NAND Timing Characteristics HPS Trace Timing Characteristics HPS GPIO Interface HPS JTAG Timing Characteristics HPS Programmable I/O Timing Characteristics
Configuration Specifications x
General Configuration Timing Specifications POR Specifications External Configuration Clock Source Requirements JTAG Configuration Timing AS Configuration Timing Avalon® Streaming (Avalon®-ST) Configuration Timing Configuration Bit Stream Sizes
Agilex™ 7 FPGAs and SoCs Device Data Sheet: F-Series and I-Series

F-Tile Transceiver Power Supply Recommended Operating Conditions

Table 11.  F-Tile Transceiver Power Supply Recommended Operating Conditions

To prevent F-Tile performance degradation, devices with F-Tile must not remain in a powered-up and unconfigured state for a cumulative time exceeding 12 months.

For specification status, see the Data Sheet Status table
Symbol Description Typical DC Level (V) Recommended DC Setpoint (% of Vnominal) Recommended VR Ripple (% of Vnominal) Recommended AC Transient (% of Vnominal) Maximum (DC Setpoint + Ripple + AC Transient) (% of Vnominal) Unit
VCC_HSSI_GXF F-Tile digital signal power supply 0.8 ±0.5% ±0.5% ±2%18 ±3% V
VCCFUSECORE_GXF F-Tile fuse writing power supply 1 ±0.5% ±4.5% ±5% V
VCCFUSEWR_GXF F-Tile efuse power supply 1 ±0.5% ±4.5% ±5% V
VCCCLK_GXF Reference clock power supply 1.8 ±0.5% ±0.5% ±2% ±3% V
VCCERT1_FHT_GXF 19 FHT analog core supply 1 1 ±0.5% ±0.5% ±1.5% ±2.5% V
VCCERT2_FHT_GXF 20 FHT analog core supply 2 1 ±0.5% ±0.5% ±1.5% ±2.5% V
VCCEHT_FHT_GXF 21 FHT high voltage power supply for analog circuit 1.5 ±0.5% ±0.5% +1%/–1.5% +2%/–2.5% V
VCCERT_FGT_GXF 22 FGT analog core supply alone 1 ±0.5% ±0.5% ±2% ±3% V
FGT analog core supply when combined with VCCERT1_FHT_GX and VCCERT2_FHT_GXF 1 V supply 1 ±0.5% ±0.5% ±1.5% ±2.5% V
VCCH_FGT_GXF 22 FGT analog I/O power supply 1.8 ±0.5% ≤5 mV ±1.5% ±3% V
Related Information
18 Board design can use 2.5% as indicated by AN910 if the simulation results include both VR ripple and AC transcient.
19 HF noise requires AC 10 mVpp above 1 MHz; switching regulator ripple switching frequency: <1 MHz, ripple: ≤5 mVpp.
20 HF noise requires AC 30 mVpp above 1 MHz; switching regulator ripple switching frequency: <1 MHz, ripple: ≤5 mVpp.
21 HF noise requires AC 30 mVpp above 1 MHz; switching regulator ripple switching frequency: <1 MHz, ripple: ≤7 mVpp.
22 HF noise requires AC 30 mVpp above 1 MHz; switching regulator ripple: ≤5 mVpp.
Level Two Title