Altera® Quartus® Prime Standard Edition Settings File Reference Manual

ID 683084
Date 5/08/2017
Public
Document Table of Contents

1.10.227. OPTIMIZE_MULTI_CORNER_TIMING

Controls whether the Fitter optimizes a design to meet timing requirements at all process corners and operating conditions. The Optimize Timing logic option must be enabled for this option to work. When this setting is turned off, designs are optimized to meet timing only at the slow timing process corner and operating condition. When this option is turned on, designs are optimized to meet timing at all corners and operating conditions; as a result, turning on this option helps create a design implementation that is more robust across process, temperature, and voltage variations.\r\n\r\nTurning on this option does not enable multi-corner timing analysis. To enable multi-corner timing analysis, see the TimeQuest Timing Analyzer page of the Settings dialog box.

Old Name

OPTIMIZE_FAST_CORNER_TIMING, Optimize Fast-Corner Timing

Type

Boolean

Device Support

  • Arria 10
  • Arria GX
  • Arria II GX
  • Arria II GZ
  • Arria V
  • Arria V GZ
  • Cyclone
  • Cyclone 10 LP
  • Cyclone II
  • Cyclone III
  • Cyclone III LS
  • Cyclone IV E
  • Cyclone IV GX
  • Cyclone V
  • EPC1
  • EPC2
  • Enhanced Configuration Devices
  • A
  • B
  • E
  • FLEX8000
  • Flash Memory
  • HardCopy II
  • HardCopy III
  • HardCopy IV
  • MAX 10
  • MAX II
  • MAX V
  • MAX3000A
  • MAX7000A
  • MAX7000AE
  • MAX7000B
  • MAX7000S
  • MAX9000
  • Mercury
  • Stratix
  • Stratix GX
  • Stratix II
  • Stratix II GX
  • Stratix III
  • Stratix IV
  • Stratix V
  • Virtual JTAG TAP

Notes

This assignment is included in the Fitter report.

Syntax


		set_global_assignment -name OPTIMIZE_MULTI_CORNER_TIMING <value>