Single-Ended I/O Standards Specifications Single-Ended SSTL, HSTL, and HSUL I/O Reference Voltage Specifications Single-Ended SSTL, HSTL, and HSUL I/O Standards Signal Specifications Differential SSTL I/O Standards Specifications Differential HSTL and HSUL I/O Standards Specifications Differential I/O Standards Specifications
Transceiver Performance for Intel® Arria® 10 GX/SX Devices High-Speed Serial Transceiver-Fabric Interface Performance for Intel® Arria® 10 GX/SX Devices Transceiver Performance for Intel® Arria® 10 GT Devices High-Speed Serial Transceiver-Fabric Interface Performance for Intel® Arria® 10 GT Devices Transceiver Specifications for Intel® Arria® 10 GX, SX, and GT Devices
High-Speed I/O Specifications DPA Lock Time Specifications LVDS Soft-CDR/DPA Sinusoidal Jitter Tolerance Specifications Memory Standards Supported by the Hard Memory Controller Memory Standards Supported by the Soft Memory Controller Memory Standards Supported by the HPS Hard Memory Controller DLL Range Specifications DQS Logic Block Specifications Memory Output Clock Jitter Specifications OCT Calibration Block Specifications
HPS Reset Input Requirements HPS Clock Performance HPS PLL Specifications Quad SPI Flash Timing Characteristics SPI Timing Characteristics SD/MMC Timing Characteristics USB ULPI Timing Characteristics Ethernet Media Access Controller (EMAC) Timing Characteristics I2C Timing Characteristics NAND Timing Characteristics Trace Timing Characteristics GPIO Interface
POR Specifications JTAG Configuration Timing FPP Configuration Timing AS Configuration Timing DCLK Frequency Specification in the AS Configuration Scheme PS Configuration Timing Initialization Configuration Files Minimum Configuration Time Estimation Remote System Upgrades User Watchdog Internal Circuitry Timing Specifications
129 To enable CLKUSR as the initialization clock source, in the Intel® Quartus® Prime software, select Device and Pin Options > General > Device initialization clock source > CLKUSR pin.
130 If you use the CLKUSR pin for AS and transceiver calibration simultaneously, the only allowed frequency is 100 MHz.
Did you find the information on this page useful?