AN 669: Drive-On-Chip Design Example for Cyclone V Devices

ID 683466
Date 5/15/2022
Public
Document Table of Contents

Using Speed Control

  1. Under Speed Demo Setup enter Speed Value 1, Speed Value 2, and Speed Interval, to set the speed and time interval between speed value switches. You can select speeds from –3,000 to +3,000 rpm.
  2. Click Run Speed Demo to start a sequence where System Console switches the motor speed command alternately between the two speeds at the specified time interval.
  3. Alternatively, select a new Speed Request value in the drop-down list.

Did you find the information on this page useful?

Characters remaining:

Feedback Message