AN 669: Drive-On-Chip Design Example for Cyclone V Devices

ID 683466
Date 5/15/2022
Public
Document Table of Contents

System Console Dials

On the General tab, System Console displays the following dials:

  • DSP Latency:
    • Measures the runtime of the field-oriented control (FOC) algorithm with software timers in the interrupt service routine (ISR)
    • Shows the time taken to execute the algorithm in the different DSP modes
  • Speed. The instantaneous speed (rpm) of the motor
  • Position. The position of the motor shaft in degrees. System Console sets the scale automatically based on the parameters you configure in the position demonstration.
Note: If you set Position Interval to less than several seconds, you may not see the changes on the dial because of the update rate of the GUI.

Did you find the information on this page useful?

Characters remaining:

Feedback Message