DSP Builder for Intel® FPGAs (Advanced Blockset): Handbook

ID 683337
Date 6/20/2022

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents Testbench Error Messages

Typical error messages have the following form:

# ** Error (vcom-13) Recompile <path>altera_mf.altera_mf_components because <path>iee.std_logic_1164 has changed.


# ** Error: <path>mdl_name_system_subsystem_component.vhd(30): (vcom-1195) Cannot find expanded name: 'altera_mf.altera_mf_components'.


# ** Error: <path>vcom failed.


# At least one module failed to compile, not starting simulation.

These errors may occur when a ModelSim precompiled model is out of date, but not automatically recompiled. A similar problem may occur after making design changes when ModelSim has cached a previously compiled model for a component and does not detect when it changes. In either of these cases, delete the rtl directory, resimulate your design and run the dspba.runModelsimATB or run_all_atbs command again.

If you run the Quartus Prime Fitter, the command also reports whether the design achieves the target fMAX. For example:

Met FMax Requirement (FMax(291.04) >= Required(200))

A summary also writes to a file results.txt in the current working directory. For example:

Starting demo_agc Tests at 2009-01-23 14:58:48

demo_agc: demo_agc/AGC_Chip/AGC hardware matches simulation (atb#1):


demo_agc: Quartus Prime compilation was successful.

(Directory=../quartus_demo_agc_AGC_Chip_2): PASSED

demo_agc: Met FMax Requirement (FMax(291.04) >= Required(200)):


Finished demo_agc Tests at 2009-01-23 15:01:59 (3 Tests, 3 Passes, 0 Skipped, 0 Failed (fmax), 0 Failed (non-fmax))