A newer version of this document is available. Customers should click here to go to the newest version.
Visible to Intel only — GUID: vgo1417242561720
Ixiasoft
Visible to Intel only — GUID: vgo1417242561720
Ixiasoft
4.3.1.1. Clock Recovery Core Parameters
Parameter | Default Value | Description |
---|---|---|
SYMBOLS_PER_CLOCK | 4 | Specifies the configuration of the DisplayPort RX transceiver used. Set to 2 for 20-bit mode (Dual symbol) or to 4 for 40-bit mode (Quad symbol). |
CLK_PERIOD_NS | 10 | Specifies the period (in nanoseconds) of the control clock input signal connected to the port.
Note: The recommended control clock frequency is 60 MHz. Set this parameter to 17.
|
DEVICE_FAMILY | Arria V | Identifies the device used. The values are Arria V, Cyclone V, and Stratix V. |
FIXED_NVID | 0 | Specifies the configuration of the DisplayPort RX received video clocking used. Set to 1 for asynchronous clocking, where the Nvid value is fixed to 32’h8000. Set to 0 if the value of Nvid is a variable of 32'h8000 or any other value.
Note: Most DisplayPort source devices transmit video using asynchronous clocking. For optimized resource usage, Intel recommends you to set the FIXED_NVID parameter to 1.
|
PIXELS_PER_CLOCK | 4 | Specifies how many pixels in parallel (for each clock cycle) are gathered from the DisplayPort RX. Set to 1 for single pixel, 2 for dual, or 4 for quad pixels per clock cycle. |
BPP | 48 | Specifies the width (in bits) of a single pixel. Set to 18 for 6-bit color, 24 for 8-bit color, and so on up to 48 for 16-bit color. |