DisplayPort Intel® FPGA IP User Guide

ID 683273
Date 4/29/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

8.1.3. View the Results

You can view the results in the ModelSim* GUI by loading various .do files in the Wave viewer.

  1. Launch the ModelSim* GUI with the vsim command.
  2. In the ModelSim* Tcl window, execute the dataset open command: dataset open vsim.wlf
  3. Select View > Open Wave files.
  4. Load the .do files to view the waveforms (refer back to Table 7-1 for a listing of the files).

    Figure 43. RX Reconfiguration WaveformIn the timing diagram below, rx_link_rate is set to 1 (HBR). When the core makes a request, the rx_reconfig_req port goes high. The user logic asserts rx_reconfig_ack and then reconfigures the transceiver. During reconfiguration, the user logic holds rx_reconfig_busy high; the user logic drives it low when reconfiguration completes.

    Figure 44. TX Reconfiguration WaveformIn the timing diagram below, tx_link_rate is set to 1 (HBR). When the core makes a request, the tx_reconfig_req port goes high. The user logic asserts tx_reconfig_ack and then reconfigures the transceiver. During reconfiguration, the user logic holds tx_reconfig_busy high; the user logic drives it low when reconfiguration completes.

    Figure 45. TX Analog Reconfiguration Waveform In the timing diagram below, tx_vod and tx_emp are both set to 00. When the core makes a request, the tx_analog_reconfig_req port goes high. The user logic asserts tx_analog_reconfig_ack and then reconfigures the transceiver. During reconfiguration, the user logic holds tx_analog_reconfig_busy high; the user logic drives it low when reconfiguration completes.

    Figure 46. RX Video WaveformThis timing diagram shows an example RX video waveform when interfacing to CVI. The rx_vid_eol signal generates the h_sync pulse by delaying it (by 1 clock cycle) to appear in the horizontal blanking period after the active video ends (VALID is deasserted). The rx_vid_eof signal generates the v_sync pulse by delaying it (by 1 clock cycle) to appear in the vertical blanking period after the active video ends (VALID is deasserted).