DisplayPort Intel® FPGA IP User Guide

ID 683273
Date 4/29/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

6.6.8. Transceiver Reconfiguration Interface

You can reconfigure the transceiver to accept a single reference clock of 135 MHz for all DP1.4 bit rates: RBR, HBR, HBR2, and HBR3. DP2.0 bit rate at UHBR10 uses reference clock at 100 MHz.

During run-time, you can reconfigure the transceiver to operate in either one of the bit rates by changing RX CDR PLLs divider ratio.

When the IP makes a request, the rx_reconfig_req port goes high. The user logic asserts rx_reconfig_ack, and then reconfigures the transceiver. During reconfiguration, the user logic holds rx_reconfig_busy high. The user logic drives it low when reconfiguration completes.

Note: The transceiver requires a reconfiguration controller. Reset the transceiver to a default state upon power-up.