5.5. LAI Core Parameters
The table lists the LAI file core parameters:
|Pin Count||1 - 255||Number of pins dedicated to the LAI. You must connect the pins to a debug header on the board.
Within the device, The Compiler maps each pin to a user-configurable number of internal signals.
|Bank Count||1 - 255||Number of internal signals that you want to map to each pin.
For example, a Bank Count of 8 implies that you connect eight internal signals to each pin.
|Output/Capture Mode||Specifies the acquisition mode. The two options are:
|Clock||Specifies the sample clock. You can use any signal in the design as a sample clock. However, for best results, use a clock with an operating frequency fast enough to sample the data that you want to acquire.
Note: The Clock parameter is available only when Output/Capture Mode is set to Registered State.
|Power-Up State||Specifies the power-up state of the pins designated for use with the LAI. You can select tri-stated for all pins, or selecting a particular bank that you enable.|
Did you find the information on this page useful?