Serial Lite IV Intel® FPGA IP User Guide

ID 683655
Date 12/01/2021
Public
Document Table of Contents

3.2.3. RX CRC

You can enable the TX CRC block using the Enable CRC parameter in the IP Parameter Editor. This feature is supported in both Basic and Full modes.

The RX CRC block interfaces with the RX Control Word Removal and RX MII Decoder blocks. The IP asserts rx_crc_error signal when a CRC error occurs.

The IP deasserts the rx_crc_error at every new burst. It is an output to the user logic for user logic error handling.

Did you find the information on this page useful?

Characters remaining:

Feedback Message