1. Introduction 2. Core Partition Reuse Debug—Developer 3. Core Partition Reuse Debug—Consumer 4. Root Partition Reuse Debug—Developer 5. Root Partition Reuse Debug—Consumer 6. Document Revision History for AN 894: Signal Tap Tutorial with Design Block Reuse for Intel® Cyclone® 10 GX FPGA Development Board
2.1. Step 1: Creating a Core Partition 2.2. Step 2: Creating Partition Boundary Ports 2.3. Step 3: Compiling and Checking Debug Nodes 2.4. Step 4: Exporting the Core Partition and Creating the Black Box File 2.5. Step 5: Copying Files to Consumer Project 2.6. Step 6: Creating a Signal Tap File (Optional) 2.7. Step 7: Programming the Device and Verifying the Hardware 2.8. Step 8: Verifying Hardware with Signal Tap
3.1. Step 1: Adding Files and Running Synthesis 3.2. Step 2: Creating a Signal Tap File 3.3. Step 3: Creating a Partition for blinking_led_top 3.4. Step 4: Compiling the Design and Verifying Debug Nodes 3.5. Step 5: Programming the Device and Verifying the Hardware 3.6. Step 6: Verifying Hardware with Signal Tap
4.1. Step 1: Creating a Reserved Core Partition and Defining a Logic Lock Region 4.2. Step 2: Generating and Instantiating SLD JTAG Bridge Agent in the Root Partition 4.3. Step 3: Generating and Instantiating the SLD JTAG Bridge Host 4.4. Step 4: Generating HDL Instance of Signal Tap 4.5. Step 5: Compiling Export Root Partition and Copying Files to Consumer Project 4.6. Step 6: Programming the Device and Verifying the Hardware 4.7. Step 7: Generating a Signal Tap File for the Root Partition 4.8. Step 8: Verifying the Hardware with Signal Tap
5.1. Step 1: Adding Files to Customer Project 5.2. Step 2: Generating and Instantiating SLD JTAG Bridge Host in Reserved Core Partition 5.3. Step 3: Synthesizing, Creating Signal Tap File, and Compiling 5.4. Step 4: Programming the Device and Verifying the Hardware 5.5. Step 5: Verifying the Hardware of Reserved Core Partition with Signal Tap 5.6. Step 6: Verifying Hardware of Root Partition with Signal Tap
5.4. Step 4: Programming the Device and Verifying the Hardware
- Program the device, as Step 7: Programming the Device and Verifying the Hardware describes.
- After programming is complete, verify the following:
- LEDs D21-D20 map to the blinking_led_top core
- LEDs D19-D22 map to the top-level (root) design
Did you find the information on this page useful?