AN 894: Signal Tap Tutorial with Design Block Reuse: for Intel® Cyclone® 10 GX FPGA Development Board

ID 683454
Date 11/11/2019
Public
Document Table of Contents

2.3. Step 3: Compiling and Checking Debug Nodes

  1. Click Compile Design on the Compilation Dashboard.
    Figure 13. Full Compilation in Compilation Dashboard
  2. Open the compilation report by clicking Processing > Compilation Report.
  3. Under Table of Contents, find Synthesis > In-System Debugging > Create Partition Boundary Ports.
    Figure 14. Create Partition Boundary Ports

Did you find the information on this page useful?

Characters remaining:

Feedback Message