Video and Vision Processing Suite Intel® FPGA IP User Guide

ID 683329
Date 4/03/2023

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
1. About the Video and Vision Processing Suite 2. Getting Started with the Video and Vision Processing IPs 3. Video and Vision Processing IPs Functional Description 4. Video and Vision Processing IP Interfaces 5. Video and Vision Processing IP Registers 6. Video and Vision Processing IPs Software Programming Model 7. Protocol Converter Intel® FPGA IP 8. 3D LUT Intel® FPGA IP 9. AXI-Stream Broadcaster Intel® FPGA IP 10. Chroma Key Intel® FPGA IP 11. Chroma Resampler Intel® FPGA IP 12. Clipper Intel® FPGA IP 13. Clocked Video Input Intel® FPGA IP 14. Clocked Video to Full-Raster Converter Intel® FPGA IP 15. Clocked Video Output Intel® FPGA IP 16. Color Space Converter Intel® FPGA IP 17. Deinterlacer Intel® FPGA IP 18. FIR Filter Intel® FPGA IP 19. Frame Cleaner Intel® FPGA IP 20. Full-Raster to Clocked Video Converter Intel® FPGA IP 21. Full-Raster to Streaming Converter Intel® FPGA IP 22. Genlock Controller Intel® FPGA IP 23. Generic Crosspoint Intel® FPGA IP 24. Genlock Signal Router Intel® FPGA IP 25. Guard Bands Intel® FPGA IP 26. Interlacer Intel® FPGA IP 27. Mixer Intel® FPGA IP 28. Pixels in Parallel Converter Intel® FPGA IP 29. Scaler Intel® FPGA IP 30. Stream Cleaner Intel® FPGA IP 31. Switch Intel® FPGA IP 32. Tone Mapping Operator Intel® FPGA IP 33. Test Pattern Generator Intel® FPGA IP 34. Video Frame Buffer Intel® FPGA IP 35. Video Streaming FIFO Intel® FPGA IP 36. Video Timing Generator Intel® FPGA IP 37. Warp Intel® FPGA IP 38. Design Security 39. Document Revision History for Video and Vision Processing Suite User Guide

21.3. Full-Raster to Streaming Converter Block Description

The IP accepts full-raster video input format as a full-raster interface of pixel data and timing markers embedded in the TDATA bus of an AXI4-S interface. Also, the IP filters out the timing markers from the TDATA bus and provides a video-active only data format on the output interfaces that conforms to the Intel FPGA streaming video protocol specification.
Figure 53. Full-Raster to Streaming Converter high-level block diagram.The figure shows the IP consists of two blocks: a full-raster stripper and an asynchronous FIFO buffer.

The full-raster stripper strips the full-raster timing information from the AXI4-S full-raster stream, leaving active-video data on the AXI4-S lite bus. The IP strips the timing information by setting the AXI4-S TVALID signal low during the blanking interval. When the input AXI4-S full-raster bus sets its TUSER signal high, the IP is in blanking. The stripper holds the TUSER high until the IP transmits the first active pixel.

Figure 54. Full-Raster to Streaming Converter Timing DiagramAn example of how the output TUSER signal is generated by detecting and holding the input TUSER signal on the full-raster video domain, until the first active pixel is detected on the TDATA bus.

The full-raster stripper has a pixel formatter logic, which is mainly based on a barrel shifter logic. It allows the IP to detect the correct position of the start of field for a pixel in parallel scenarios. It aligns the tdata packet content on the output video stream to ensure that the start of field always coincides with pixel 0.

The IP assumes that the transmitter side generates video data with a slower or faster pixel clock rate compared to the receiver video interface. Consequently, moving video data between two different clock domains requires clock domain crossings. Additionally, the TVALID and TREADY flow-controlled AXI4-S video interface may cause the following control-flow problems on the video datapath:

  • Clock-skew matching, if video receiver and transmitter and video processing clocks do not match.
  • In-rush of data if one of the modules in the video pipeline cannot offer the necessary throughput to move the data at the expected rate.

This IP includes an asynchronous output FIFO buffer that handles clock crossing domains between the full-raster and video processing clock domains. Additionally, it temporally accepts data to accommodate a small amount of data-skew mismatching or in-rush data when transferring data between full-raster and active-video only video interfaces.