Intel® Agilex™ SEU Mitigation User Guide

ID 683128
Date 12/30/2022

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

4.2. Setting Up the SEU Mitigation Features

Perform these steps to set up the Intel® Agilex™ SEU detection, enable internal scrubbing, enable sensitivity map generation, and allowing fault injection.
  1. From the Intel® Quartus® Prime menu, select Assignments > Device.
  2. In the Device window, click Device and Pin Options
  3. In the Device and Pin Options windows, navigate to Error Detection CRC.
  4. Specify the following options:
    Setting Description
    Enable error detection check Turn on to enable the error detection feature. This option is required for sensitivity processing and fault injection, or if you want to observe the SEU_ERROR pin behavior.
    Minimum SEU interval Enter a value of 0 to 10000 milliseconds to set the minimum time between two checks of the same bit. To check as frequently as possible, enter 0.

    The actual minimum interval may be higher than the value you specify. The System Message window reports the actual value when you select a generated .sof file as an input file in the Intel® Quartus® Prime Programming File Generator or Programmer.

    Note: To determine the minimum SEU detection interval of the device, set Minimum SEU interval to 0 or any value that is lower than the actual minimum interval.
    Enable internal scrubbing Turn on to enable the error correction feature. This option is required for sensitivity processing.
    Generate SEU sensitivity map file (.smh) Turn on to generate the .smh file. This option is required for sensitivity processing.
    Allow SEU fault injection Turn on to enable injecting fault using the Fault Injection Debugger.
  5. Click OK.