Visible to Intel only — GUID: sam1396416648298
Ixiasoft
1. Intel® MAX® 10 External Memory Interface Overview
2. Intel® MAX® 10 External Memory Interface Architecture and Features
3. Intel® MAX® 10 External Memory Interface Design Considerations
4. Intel® MAX® 10 External Memory Interface Implementation Guides
5. UniPHY IP References for Intel® MAX® 10 Devices
6. Intel® MAX® 10 External Memory Interface User Guide Archives
7. Document Revision History for the Intel® MAX® 10 External Memory Interface User Guide
2.1. Intel® MAX® 10 I/O Banks for External Memory Interface
2.2. Intel® MAX® 10 DQ/DQS Groups
2.3. Intel® MAX® 10 External Memory Interfaces Maximum Width
2.4. Intel® MAX® 10 Memory Controller
2.5. Intel® MAX® 10 External Memory Read Datapath
2.6. Intel® MAX® 10 External Memory Write Datapath
2.7. Intel® MAX® 10 Address/Command Path
2.8. Intel® MAX® 10 PHY Clock (PHYCLK) Network
2.9. Phase Detector for VT Tracking
2.10. On-Chip Termination
2.11. Phase-Locked Loop
2.12. Intel® MAX® 10 Low Power Feature
3.1. Intel® MAX® 10 DDR2 and DDR3 Design Considerations
3.2. LPDDR2 Design Considerations
3.3. Guidelines: Intel® MAX® 10 DDR3, DDR2, and LPDDR2 External Memory Interface I/O Limitation
3.4. Guidelines: Intel® MAX® 10 Board Design Requirement for DDR2, DDR3, and LPDDR2
3.5. Guidelines: Reading the Intel® MAX® 10 Pin-Out Files
Visible to Intel only — GUID: sam1396416648298
Ixiasoft
2.1. Intel® MAX® 10 I/O Banks for External Memory Interface
In Intel® MAX® 10 devices, external memory interfaces are supported only on the I/O banks on the right side of the device. You must place all external memory I/O pins on the I/O banks on the right side of the device.
Figure 2. I/O Banks for External Memory Interfaces This figure represents the top view of the silicon die that corresponds to a reverse view of the device package.
External memory interfaces support is available only for dual supply (DC, DF, and DA) variant on 10M16, 10M25, 10M40, and 10M50 devices.
Did you find the information on this page useful?
Feedback Message
Characters remaining: