Intel® Stratix® 10 General Purpose I/O User Guide

ID 683518
Date 7/07/2021
Public
Document Table of Contents

2.3.1. Programmable Output Slew Rate Control

You can specify the slew rate on a pin-by-pin basis because each I/O pin contains a slew rate control. The slew rate control affects both the rising and falling edges.

You can select between two slew rate settings, 1 and 0:

  • Fast slew rate (1)—provides high-speed transitions for high-performance systems. This is the default setting. If you enable on-chip termination (OCT), this setting is always used.
  • Slow slew rate (0)—reduces system noise and crosstalk but adds a nominal delay to the rising and falling edges.

Note: Intel recommends that you perform IBIS or SPICE simulations to determine the best slew rate setting for your specific application.

Did you find the information on this page useful?

Characters remaining:

Feedback Message