DisplayPort Intel® FPGA IP User Guide

ID 683273
Date 10/20/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

6.6.8. Transceiver Reconfiguration Interface

You can reconfigure the transceiver to accept a single or dual reference clocks depending on the design variant.

Table 56.  Transceiver Reconfiguration for Different Design Variants
Devices Data Rate Reference Clock Frequency Description
Intel FPGA Cyclone 10, Intel FPGA Arria 10 RBR, HBR, HBR2, HBR3 135 MHz Single reference clock for all HBR* data rates
Intel FPGA Stratix 10 RBR, HBR, HBR2, HBR3 135 MHz Reference clock switching required between HBR* rate and UHBR* rate
UHBR10, UHBR20 100 MHz
Intel FPGA Agilex RBR, HBR, HBR2, HBR3, UHBR10 150 MHz Single reference clock for all HBR* and UHBR* data rates

*Refer to respective Design Example User Guides for more details.

During run-time, you can reconfigure the transceiver to operate in either one of the bit rates by changing RX CDR PLLs divider ratio.

When the IP makes a request, the rx_reconfig_req port goes high. The user logic asserts rx_reconfig_ack, and then reconfigures the transceiver. During reconfiguration, the user logic holds rx_reconfig_busy high. The user logic drives it low when reconfiguration completes.

Note: The transceiver requires a reconfiguration controller. Reset the transceiver to a default state upon power-up.