Hard Processor System Component Reference Manual: Agilex™ 5 SoCs

ID 813752
Date 4/01/2024
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.2.4.2. Steps to run the Simulation in Synopsys* VCS*

  1. In agilex5_hps_f2sdram_simulation_tb/agilex5_hps_f2sdram_simulation_tb/sim/synopsys/vcs/vcs_setup.sh, modify the “QUARTUS_INSTALL_DIR” to point to the correct Quartus® Prime installation path. (This step is not required if your design is generated per RTL Simulation Setup Scripts).
  2. In the top directory, launch the VCS* simulator with command:
    bash vcs_run.sh 64
    The standard output from the VCS* test and simulation process is printed out on the terminal.
  3. To view the signal waveforms, navigate to the VCS* directory:
    cd agilex5_hps_f2h_simulation_tb/ \
    agilex5_hps_f2h_simulation_tb/sim/synopsys/vcs
  4. Launch the VCS* GUI using the command:
    simv -gui &
  5. In the GUI window, you may add in waveform signals by selecting right-click on the signal group, and choosing Add to Waves > New Wave View.
    Figure 67. New Wave View
  6. A new Waveform View window is launched. From the window, click on the “Start/Continue” button or press “F5” key to run the waveform simulation.
    Figure 68. New Waveform View window
  7. When the simulation is completed, you can zoom in to view the waveform of each signal.
    Figure 69. Waveform View (Zoom In)