Visible to Intel only — GUID: toh1686332933023
Ixiasoft
2.1. Parameterizing the HPS Component
2.2. HPS-FPGA Interfaces
2.3. SDRAM
2.4. HPS Clocks, Reset, Power
2.5. I/O Delays
2.6. Pin Mux and Peripherals
2.7. Generating and Compiling the HPS Component
2.8. Using the Address Span Extender Component
2.9. Configuring the Agilex™ 5 Hard Processor System Component Revision History
2.2.1.1. Enable MPU Standby and Event Signals
2.2.1.2. Enable General Purpose Signals
2.2.1.3. Enable Debug APB* Interface
2.2.1.4. Enable System Trace Macrocell (STM) Hardware Events
2.2.1.5. Enable SWJ-DP JTAG Interface
2.2.1.6. Enable FPGA Cross Trigger Interface
2.2.1.7. Enable AMBA* Trace Bus (ATB)
3.1. Simulation Flows
3.2. Running the Simulation of the Design Examples
3.3. Clock and Reset Interface
3.4. FPGA-to-HPS AXI* Subordinate Interface
3.5. FPGA-to-SDRAM AXI* Subordinate Interface
3.6. HPS-to-FPGA AXI* Initiator Interface
3.7. Lightweight HPS-to-FPGA AXI* Initiator Interface
3.8. Simulating the Agilex™ 5 HPS Component Revision History
Visible to Intel only — GUID: toh1686332933023
Ixiasoft
2.4.2.2. Peripheral PLL Output
The default calculated PLL VCO and channel frequencies are displayed in a table. You can select the Peripheral PLL Clock Source by the drop-down selection, HPS External Oscillator, and FPGA Free Clock.
Turning on Override Peripheral PLL Settings exposes the peripheral PLL clocks desired frequency. You can configure the desired frequency by override the value of each of peripheral PLL frequency.
Figure 14. Platform Designer Peripheral PLL Output Sub-window