AN 866: Mitigating and Debugging Single Event Upsets in Intel® Quartus® Prime Standard Edition

ID 683869
Date 9/28/2021
Document Table of Contents

2.3.3. Using the Fault Injection Debugger

To use the Fault Injection Debugger, you connect to your device via the JTAG interface. Then, configure the device and perform fault injection.

To launch the Fault Injection Debugger, choose Tools > Fault Injection Debugger in the Intel® Quartus® Prime software.
Note: Configuring or programming the device is similar to the procedure used for the Programmer or Signal Tap Logic Analyzer.
Figure 12. Fault Injection Debugger

To configure your JTAG chain:

  1. Click Hardware Setup. The tool displays the programming hardware connected to your computer.
  2. Select the programming hardware you wish to use.
  3. Click Close.
  4. Click Auto Detect, which populates the device chain with the programmable devices found in the JTAG chain.

Did you find the information on this page useful?

Characters remaining:

Feedback Message