MAX 10 FPGA Development Kit User Guide

Download PDF
ID 683460
Date 9/07/2017
Public
Document Table of Contents
Document Table of Contents x
1. Overview 2. Getting Started 3. Board Test System 4. Board Components A. Additional Information
1. Overview x
1.1. General Description 1.2. Handling the Board
2. Getting Started x
2.1. Quartus II Web Edition Software 2.2. Installing the Development Kit 2.3. Installing the USB-Blaster Driver 2.4. Board Update Portal
3. Board Test System x
3.1. Using the Configure Menu 3.2. The System Info Tab 3.3. The GPIO Tab 3.4. The Flash Tab 3.5. The HSMC Tab 3.6. The DDR3 Tab 3.7. The ADC Tab 3.8. The HDMI Tab 3.9. The Sleep Mode Tab 3.10. The Power Monitor 3.11. The Clock Control
4. Board Components x
4.1. Board Overview 4.2. Featured Device 4.3. Configuration 4.4. Status Elements 4.5. Setup Elements 4.6. General User Input/Output 4.7. Clock Circuitry 4.8. Components and Interfaces 4.9. Memory 4.10. Power Distribution System
4.3. Configuration x
4.3.1. Using the Quartus II Programmer 4.3.2. Selecting the Internal Configuration Scheme 4.3.3. Switch and Jumper Settings
4.7. Clock Circuitry x
4.7.1. On-Board Oscillators 4.7.2. Off-Board Clock Input/Output
4.8. Components and Interfaces x
4.8.1. 10/100/1000 Ethernet PHY 4.8.2. Digital-to-Analog Converter 4.8.3. HDMI Video Output 4.8.4. HSMC 4.8.5. Pmod Connectors 4.8.6. USB to UART
4.9. Memory x
4.9.1. DDR3 Rev. B Board 4.9.2. DDR3 Rev. C Board 4.9.3. Flash
A. Additional Information x
A.1. User Guide Revision History A.2. Compliance and Conformity Statements
A.2. Compliance and Conformity Statements x
A.2.1. CE EMI Conformity Caution
1. Overview
2. Getting Started
3. Board Test System
4. Board Components
A. Additional Information

2.2. Installing the Development Kit

  1. Download the MAX 10 Development Kit installer from the MAX 10 FPGA Development Kit page of the Altera website. Alternatively, you can request a development kit DVD from the Altera Kit Installations DVD Request Form page of the Altera website.
  2. Run the MAX 10 FPGA Development Kit installer.
  3. Follow the on-screen instructions to complete the installation process. Be sure that the installation directory you choose is in the same relative location to the Quartus II software installation.
    The installation program creates the development kit directory structure shown in the following figure.
    Attention: .sof files are used by BTS GUI to configure the MAX 10 device and start corresponding test. Therefore, do not to move the .sof files from the *\examples\board_test_system directory.
    Figure 4. Installed Development Kit Directory Structure
    Table 1.  Installed Directory Contents
    Directory Name Description of Contents
    board_design_files Contains schematic, layout, assembly, and bill of material board design files. Use these files as a starting point for a new prototype board design.
    demos Contains demonstration applications when available.
    documents Contains the following documentation:
    • MAX 10 FPGA Development Kit User Guide
    • Quick Start Guide
    • Dear Customer Letter
    examples Contains the sample design files for this kit.
    factory_recovery Contains the original data programmed onto the board before shipment. Use this data to restore the board with its original factory contents.
Level Two Title