Intel® MAX® 10 FPGA 10M50 Evaluation Kit User Guide

Download PDF
ID 683447
Date 1/11/2024
Public
Document Table of Contents
Document Table of Contents x
1. Intel® MAX® 10 FPGA 10M50 Evaluation Kit Overview 2. Getting Started 3. Board Components A. Additional Information
1. Intel® MAX® 10 FPGA 10M50 Evaluation Kit Overview x
1.1. Board Component Blocks 1.2. Supported Items Not Included with the Kit
2. Getting Started x
2.1. Powering the Kit 2.2. Installing the Intel® FPGA Download Cable II Driver 2.3. Handling the Kit 2.4. Factory Default Switch and Jumper Settings
3. Board Components x
3.1. Board Overview 3.2. Featured Device: Intel® MAX® 10 FPGA 3.3. Configuration 3.4. Status Elements 3.5. Setup Elements 3.6. General User Input/Output 3.7. Clock Circuitry 3.8. Components and Interfaces
3.3. Configuration x
3.3.1. Using the Intel® Quartus® Prime Programmer 3.3.2. Selecting the Internal Configuration Scheme
3.7. Clock Circuitry x
3.7.1. On-Board Oscillators 3.7.2. Off-Board Clock Input/Output 3.7.3. Clock Control GUI
3.7.3. Clock Control GUI x
3.7.3.1. The Clock Control
3.8. Components and Interfaces x
3.8.1. HDMI Video Output 3.8.2. Pmod Connectors 3.8.3. Memory 3.8.4. Flash 3.8.5. MIPI CSI-2 Transmitter 3.8.6. MIPI CSI-2 Receiver 3.8.7. Power Supply
3.8.3. Memory x
3.8.3.1. LPDDR2
3.8.7. Power Supply x
3.8.7.1. Power Options 3.8.7.2. Power-Up Sequence
A. Additional Information x
A.1. Document Revision History for the Intel® MAX® 10 FPGA 10M50 Evaluation Kit User Guide A.2. Safety and Regulatory Information A.3. Compliance Information
A.2. Safety and Regulatory Information x
ENGINEERING DEVELOPMENT PRODUCT - NOT FOR RESALE OR LEASE A.2.1. Safety Warnings A.2.2. Safety Cautions
1. Intel® MAX® 10 FPGA 10M50 Evaluation Kit Overview
2. Getting Started
3. Board Components
A. Additional Information

A.2. Safety and Regulatory Information

ENGINEERING DEVELOPMENT PRODUCT - NOT FOR RESALE OR LEASE

This development kit is intended for laboratory development and engineering use only.

This development kit is designed to allow:
  • Product developers and system engineers to evaluate electronic components, circuits, or software associated with the development kit to determine whether to incorporate such items in a finished product.
  • Software developers to write software applications for use with the end product.

This kit is not a finished product and when assembled may not be resold or otherwise marketed unless all required Federal Communications Commission (FCC) equipment authorizations are first obtained.

Operation is subject to the condition that this product not cause harmful interference to licensed radio stations and that this product accept harmful interference.

Unless the assembled kit is designed to operate under Part 15, Part 18 or Part 95 of the United States Code of Federal Regulations (CFR) Title 47, the operator of the kit must operate under the authority of an FCC licenseholder or must secure an experimental authorization under Part 5 of the United States CFR Title 47.

Safety Assessment and CE & UKCA mark requirements have been completed, however, other certifications that may be required for installation and operation in your region have not been obtained.


Section Content
Safety Warnings
Safety Cautions

Level Two Title