AN 1013: Using Generic QSPI Flash on Control Block-Based Devices

Download PDF
ID 855235
Date 6/30/2025
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Overview 3. Requirements 4. Implementation Flow 5. Programming Flow 6. QSPI Flash Examples 7. Document Revision History for AN 1013: Using Generic QSPI Flash on Control Block-Based Devices
3. Requirements x
3.1. I/O Standard Specification 3.2. Quad SPI Flash Byte Addressing 3.3. Disable Flash ID Check 3.4. Standard SPI Mode (1-1-1 Protocol) 3.5. Quad IO Mode (1-4-4 Protocol) 3.6. Sector Size 3.7. Maximum QSPI Clock Frequency 3.8. QSPI Read Opcode 3.9. Timing Specification
4. Implementation Flow x
4.1. Generating Programming Files Using the Convert Programming Files Feature 4.2. Programming .JIC Files into QSPI Flash Devices
5. Programming Flow x
5.1. Initialization Phase 5.2. Program Phase 5.3. Verify/Blank-Check/Examine Phase 5.4. Erase Phase 5.5. Termination
6. QSPI Flash Examples x
6.1. Cypress* S25HS512T with Cyclone® 10 GX 6.2. Macronix MX25L12833FMI-10G* with Cyclone® V
1. Introduction
2. Overview
3. Requirements
4. Implementation Flow
5. Programming Flow
6. QSPI Flash Examples
7. Document Revision History for AN 1013: Using Generic QSPI Flash on Control Block-Based Devices

4.2. Programming .JIC Files into QSPI Flash Devices

To program the .jic file into the QSPI flash device through the JTAG interface, perform the following steps.
  1. In the Programmer window, click Hardware Setup and select the desired download cable.
  2. In the Mode, select JTAG.
  3. Select the device to be programmed and click Add File.
  4. Select the .jic file to be programmed to the selected device.
  5. Click Start to begin programming.
Level Two Title