AN 1013: Using Generic QSPI Flash on Control Block-Based Devices

Download PDF
ID 855235
Date 6/30/2025
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Overview 3. Requirements 4. Implementation Flow 5. Programming Flow 6. QSPI Flash Examples 7. Document Revision History for AN 1013: Using Generic QSPI Flash on Control Block-Based Devices
3. Requirements x
3.1. I/O Standard Specification 3.2. Quad SPI Flash Byte Addressing 3.3. Disable Flash ID Check 3.4. Standard SPI Mode (1-1-1 Protocol) 3.5. Quad IO Mode (1-4-4 Protocol) 3.6. Sector Size 3.7. Maximum QSPI Clock Frequency 3.8. QSPI Read Opcode 3.9. Timing Specification
4. Implementation Flow x
4.1. Generating Programming Files Using the Convert Programming Files Feature 4.2. Programming .JIC Files into QSPI Flash Devices
5. Programming Flow x
5.1. Initialization Phase 5.2. Program Phase 5.3. Verify/Blank-Check/Examine Phase 5.4. Erase Phase 5.5. Termination
6. QSPI Flash Examples x
6.1. Cypress* S25HS512T with Cyclone® 10 GX 6.2. Macronix MX25L12833FMI-10G* with Cyclone® V
1. Introduction
2. Overview
3. Requirements
4. Implementation Flow
5. Programming Flow
6. QSPI Flash Examples
7. Document Revision History for AN 1013: Using Generic QSPI Flash on Control Block-Based Devices

3.3. Disable Flash ID Check

You must disable the flash ID check feature when using a QSPI flash that is not an EPCS or EPCQ device.
  1. In Quartus® Prime software, navigate to Files > Convert Programming Files. The Convert Programming File window appears.
  2. Click Advanced Options. The Advanced Options window appears.
  3. Turn on the Disable EPCS/EPCQ ID check option. Click OK.
    Figure 3. Disable EPCS/EPCQ ID Check
Level Two Title