AN 1013: Using Generic QSPI Flash on Control Block-Based Devices

Download PDF
ID 855235
Date 6/30/2025
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Overview 3. Requirements 4. Implementation Flow 5. Programming Flow 6. QSPI Flash Examples 7. Document Revision History for AN 1013: Using Generic QSPI Flash on Control Block-Based Devices
3. Requirements x
3.1. I/O Standard Specification 3.2. Quad SPI Flash Byte Addressing 3.3. Disable Flash ID Check 3.4. Standard SPI Mode (1-1-1 Protocol) 3.5. Quad IO Mode (1-4-4 Protocol) 3.6. Sector Size 3.7. Maximum QSPI Clock Frequency 3.8. QSPI Read Opcode 3.9. Timing Specification
4. Implementation Flow x
4.1. Generating Programming Files Using the Convert Programming Files Feature 4.2. Programming .JIC Files into QSPI Flash Devices
5. Programming Flow x
5.1. Initialization Phase 5.2. Program Phase 5.3. Verify/Blank-Check/Examine Phase 5.4. Erase Phase 5.5. Termination
6. QSPI Flash Examples x
6.1. Cypress* S25HS512T with Cyclone® 10 GX 6.2. Macronix MX25L12833FMI-10G* with Cyclone® V
1. Introduction
2. Overview
3. Requirements
4. Implementation Flow
5. Programming Flow
6. QSPI Flash Examples
7. Document Revision History for AN 1013: Using Generic QSPI Flash on Control Block-Based Devices

4. Implementation Flow

You can proceed to use the QSPI flash device for FPGA configuration after successfully verifying it meets requirements.

This section describes the steps required to generate programming files and program the verified QSPI flash using the Quartus® Prime Programmer and Generic Flash Programmer.


Section Content
Generating Programming Files Using the Convert Programming Files Feature
Programming .JIC Files into QSPI Flash Devices

Related Information
Level Two Title