A newer version of this document is available. Customers should click here to go to the newest version.
1. SDI II IP Core Quick Reference
2. SDI II IP Core Overview
3. SDI II IP Core Getting Started
4. SDI II IP Core Parameters
5. SDI II IP Core Functional Description
6. SDI II IP Core Signals
7. SDI II IP Core Design Considerations
8. SDI II IP Core Testbench and Design Examples
9. SDI II Intel® FPGA IP User Guide Archives
10. Document Revision History for the SDI II Intel® FPGA IP User Guide
5.3.1. Insert Line
5.3.2. Insert/Check CRC
5.3.3. Insert Payload ID
5.3.4. Match TRS
5.3.5. Scrambler
5.3.6. TX Sample
5.3.7. Clock Enable Generator
5.3.8. RX Sample
5.3.9. Detect Video Standard
5.3.10. Detect 1 and 1/1.001 Rates
5.3.11. Transceiver Controller
5.3.12. Descrambler
5.3.13. TRS Aligner
5.3.14. 3Gb Demux
5.3.15. Extract Line
5.3.16. Extract Payload ID
5.3.17. Detect Format
5.3.18. Sync Streams
5.3.19. Convert SD Bits
5.3.20. Insert Sync Bits
5.3.21. Remove Sync Bits
7.1.2.1. Changing RX CDR Reference Clock in Transceiver Native PHY IP Core
7.1.2.2. Merging Simplex Mode Transceiver in the Same Channel
7.1.2.3. Using Generated Reconfiguration Management for Triple and Multi Rates
7.1.2.4. Ensuring Independent RX and TX Operations in the Same Channel
7.1.2.5. Potential Routing Problem During Fitter Stage in Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
7.1.2.6. Unconstrained Clocks in SDI Multi-Rate RX Using Intel® Arria® 10 and Intel® Cyclone® 10 GX Devices
7.1.2.7. Unused Transceiver Channels
7.1.2.8. Routing Transceiver Reference Clock Pins to Core Logic in Intel® Stratix® 10 Devices
8.2.1.5. Avalon-MM Translators
The Avalon-MM Master Translator and Avalon-MM Slave Translator are Avalon-MM interface blocks that access the Transceiver Reconfiguration Controller registers. The translators are not SDI-specific and are automatically instantiated when the core interfaces with an Avalon-MM master or slave component.
If you want to bypass the Avalon MM translator in your design, connect reconfig_mgmt_address[8:2] from the reconfiguration management block to reconfig_mgmt_address from the Transceiver Reconfiguration Controller.
You can connect the other signals from the reconfiguration management block directly to the Transceiver Reconfiguration Controller.
- reconfig_mgmt_waitrequest
- reconfig_mgmt_read
- reconfig_mgmt_readdata
- reconfig_mgmt_write
- reconfig_mgmt_writedata