GTS Ethernet Hard IP User Guide: Agilex™ 3 FPGAs and SoCs
ID
848477
Date
7/07/2025
Public
1. Overview
2. Install and License the GTS Ethernet Hard IP
3. Configure and Generate Ethernet Hard IP variant
4. Integrate GTS Ethernet Hard IP into Your Application
5. Simulate and Compile (MAC+PCS) Design Example
6. Simulate and Compile (MII PCS Only/PCS66 OTN/PCS66 FlexE) Design Example
7. Simulate and Compile SyncE Design Example
8. Simulate and Compile PTP1588 Design Example
9. Simulate and Compile (Dynamically Reconfigurable Ethernet Mode)
10. Simulate and Compile - Auto-Negotiation and Link Training
11. Troubleshoot and Diagnose Issues
12. Appendix A: Functional Description
13. Appendix B: Configuration Registers
14. Appendix C: Document Revision History for the GTS Ethernet Hard IP User Guide: Agilex 3 FPGAs and SoCs
4.1. Implement Required Clocking
4.2. Implement Required Resets
4.3. Connect the Status Interface
4.4. Connect the MAC Avalon Streaming Client Interface
4.5. Connect the MII PCS Only Client Interface
4.6. Connect the PCS66 Client Interface – FlexE and OTN
4.7. Connect the Precision Time Protocol Interface
4.8. Connect the Ethernet Hard IP Reconfiguration Interface
4.9. Connect the Auto-Negotiation and Link Training
4.10. Connect the Multirate Auto-Negotiation and Link Training
4.11. Connect the Dynamically Reconfigurable Ethernet Mode
4.4.1.1. Drive the Ethernet Packet to the TX MAC Avalon Streaming Client Interface with Disabled Preamble Passthrough
4.4.1.2. Drive the Ethernet Packet on the TX MAC Avalon Streaming Client Interface with Enabled Preamble Passthrough
4.4.1.3. Use i_tx_skip_crc to Control Source Address, PAD, and CRC Insertion
4.4.1.4. Assert the i_tx_error to Invalidate a Packet
4.4.2.1. Receive Ethernet Frame on the RX MAC Avalon Streaming Client Interface with Preamble Passthrough Disabled
4.4.2.2. Receive Ethernet Frame with Preamble Passthrough Enabled
4.4.2.3. Receive Ethernet Frame with Remove CRC bytes Disabled
4.4.2.4. Monitor Status and Errors on the RX MAC Avalon Streaming Client Interface
8. Simulate and Compile PTP1588 Design Example
The IP design example supports 10GE Ethernet rate with enabled Precision Time Protocol (PTP) and demonstrates the basic functionality Ethernet with PTP.
Selected IP Parameter Settings | Value |
---|---|
General Options | |
Ethernet Operation Mode | Ethernet General |
Client interface | MAC Avalon® ST |
PMA reference frequency | 156.25 MHz |
MAC Use case | 1 Port MAC |
System PLL frequency | 322.265625 MHz |
Enable Dedicated CDR Clock Output | Unchecked |
PTP Options | |
Enable IEEE 1588 PTP | Enabled |
Timestamp fingerprint width | 8 |
Base_Profile > Port #0 IP Configuration | |
Ethernet Mode | 10G-1 |
FEC Mode | IEEE 802.3 BASE-R Firecode (CL74) – optional |
For more information about steps of how to generate a design example, refer to the Generate GTS EHIP Design Example.
Section Content
Design Example Features
Design Example Components
Simulate the Design Example
Compile the Design Example
Related Information