Visible to Intel only — GUID: zsb1569551455721
Ixiasoft
1.1. Supported Devices and Systems
1.2. Power Source Requirements
1.3. Software Requirements and Support
1.4. Installing the Intel® FPGA Download Cable II for Configuration or Programming
1.5. Installing the Intel® FPGA Download Cable II Driver on Windows 7/8/10 Systems
1.6. Installing the Intel® FPGA Download Cable II Driver on Linux Systems
1.7. Installing the Intel® FPGA Download Cable II Driver on Windows XP Systems
1.8. Setting Up the Intel® FPGA Download Cable II Hardware with the Intel® Quartus® Prime Software
2.1. Voltage Requirements
2.2. Cable-to-Board Connection
2.3. Intel® FPGA Download Cable II Plug Connection
2.4. 10-Pin Female Plug Signal Names and Programming Modes
2.5. Circuit Board Header Connection
2.6. Operating Conditions
2.7. JTAG Timing Constraints and Waveforms
2.8. Changing the TCK Frequency
Visible to Intel only — GUID: zsb1569551455721
Ixiasoft
A.1.2. Jtagserver Setting
- Open Windows OS command prompt
- Execute the following command:
jtagconfig --serverinfo
Example output message isInstalled JTAG server is ‘<Quartus Prime install folder>\quartus\bin64\jtagserver.exe' Service manager reports server is running Server reports path: <Quartus Prime install folder>\quartus \bin64\jtagserver.exe Server reports version: Version 18.1.1 Build 646 04/11/2019 SJ Standard Edition Remote clients are disabled (no password)
If the installed JTAG server doesn’t match the version of Intel® Quartus® Prime software you use, install the same version of JTAG server as the Intel® Quartus® Prime software. - Set the environment variables correctly following the steps described in the jtagconfig version setting in the sections above.
- Execute the following commands
Jtagserver –uninstall Jtagserver –install
- Restart your computer
Did you find the information on this page useful?
Feedback Message
Characters remaining: