Visible to Intel only — GUID: iga1447182597005
Ixiasoft
1.1. Supported Devices and Systems
1.2. Power Source Requirements
1.3. Software Requirements and Support
1.4. Installing the Intel® FPGA Download Cable II for Configuration or Programming
1.5. Installing the Intel® FPGA Download Cable II Driver on Windows 7/8/10 Systems
1.6. Installing the Intel® FPGA Download Cable II Driver on Linux Systems
1.7. Installing the Intel® FPGA Download Cable II Driver on Windows XP Systems
1.8. Setting Up the Intel® FPGA Download Cable II Hardware with the Intel® Quartus® Prime Software
2.1. Voltage Requirements
2.2. Cable-to-Board Connection
2.3. Intel® FPGA Download Cable II Plug Connection
2.4. 10-Pin Female Plug Signal Names and Programming Modes
2.5. Circuit Board Header Connection
2.6. Operating Conditions
2.7. JTAG Timing Constraints and Waveforms
2.8. Changing the TCK Frequency
Visible to Intel only — GUID: iga1447182597005
Ixiasoft
1.4. Installing the Intel® FPGA Download Cable II for Configuration or Programming
- Disconnect the power cable from the circuit board.
- Connect the Intel® FPGA Download Cable II to the USB port on your computer and to the download cable port.
- Connect the Intel® FPGA Download Cable II to the 10-pin header on the device board.
- Reconnect the power cable to reapply power to the circuit board.
Figure 1. The Intel FPGA Download Cable II

Note: For plug and header dimensions, pin names, and operating conditions, see the Intel FPGA Download Cable II Specifications chapter.
Related Information
Did you find the information on this page useful?
Feedback Message
Characters remaining: