Visible to Intel only — GUID: bhc1412141986494
Ixiasoft
1. About LL Ethernet 10G MAC
2. Getting Started
3. LL Ethernet 10G MAC Intel® FPGA IP Design Examples
4. Functional Description
5. Configuration Registers
6. Interface Signals
7. Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide Archives
8. Document Revision History for the Low Latency Ethernet 10G MAC Intel® FPGA IP User Guide
2.1. Introduction to Intel® FPGA IP Cores
2.2. Installing and Licensing Intel® FPGA IP Cores
2.3. Specifying the IP Core Parameters and Options ( Quartus® Prime Pro Edition)
2.4. IP Core Generation Output ( Quartus® Prime Pro Edition)
2.5. Files Generated for Intel IP Cores (Legacy Parameter Editor)
2.6. Simulating Intel® FPGA IP Cores
2.7. Creating a Signal Tap Debug File to Match Your Design Hierarchy
2.8. Parameter Settings for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.9. Upgrading the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
2.10. Design Considerations for the Low Latency Ethernet 10G MAC Intel® FPGA IP Core
5.1. Register Map
5.2. Register Access Definition
5.3. Primary MAC Address
5.4. MAC Reset Control Register
5.5. TX Configuration and Status Registers
5.6. Flow Control Registers
5.7. Unidirectional Control Registers
5.8. RX Configuration and Status Registers
5.9. Timestamp Registers
5.10. ECC Registers
5.11. Statistics Registers
6.1. Clock and Reset Signals
6.2. Speed Selection Signal
6.3. Error Correction Signals
6.4. Unidirectional Signals
6.5. Avalon® Memory-Mapped Interface Programming Signals
6.6. Avalon® Streaming Data Interfaces
6.7. Avalon® Streaming Flow Control Signals
6.8. Avalon® Streaming Status Interface
6.9. PHY-side Interfaces
6.10. IEEE 1588v2 Interfaces
Visible to Intel only — GUID: bhc1412141986494
Ixiasoft
4.8. Supported PHYs
You can connect the LL 10GbE MAC IP core to a PHY IP core using XGMII, GMII, or MII interfaces.
Operating Mode | PHY |
---|---|
10G | 10GBASE-R PHY, XAUI PHY |
1G/10G | 10GBASE-KR or 1G/10G PHY |
10M/100M/1G/10G | |
1G/2.5G | 1G/2.5G/10G Multirate Ethernet PHY |
1G/2.5G/10G | |
10M/100M/1G/2.5G | 1G/2.5G/10G Multirate Ethernet PHY (with SGMII bridge enabled) |
10M/100M/1G/2.5G/10G | |
10M/100M/1G/2.5G/5G/10G | 1G/2.5G/5G/10G Multirate Ethernet PHY |
To connect the MAC IP core to 64-bit PHYs, ensure that you enable the Use legacy Ethernet 10G MAC XGMII Interface option.
Related Information