2.1. Parsing Programming Files
2.2. Getting Device Information
2.3. Debugging QSPI Flash
2.4. QSPI Controller Settings and SFDP Values
2.5. Debugging Remote System Update
2.6. Voltage Sensor Monitoring
2.7. Temperature Sensor Monitoring
2.8. Hard Processor System (HPS) Cold Reset
2.9. Debug Log
2.10. SDM Mailbox Command
2.11. VR Diagnostic
2.12. VR Telemetry
2.13. Virtual Hardware
2.13.2.1. Reading Programming File Information from Virtual Hardware
2.13.2.2. Reading Device Information from Virtual Hardware
2.13.2.3. Accessing Flash Memory Attached to Virtual Hardware
2.13.2.4. Performing RSU with Virtual Hardware
2.13.2.5. Reading Voltage Sensor Measurement from Virtual Hardware
2.13.2.6. Reading Temperature Sensor Measurement from Virtual Hardware
2.13.2.7. Sending SDM Mailbox Commands with Virtual Hardware
3. Document Revision History for AN 955: Programmer’s Configuration Debugger Tool
Document Version | Changes |
---|---|
2025.09.29 | Added support for Virtual Hardware, to match support available in Quartus® Prime Design Suite version 25.3. |
2025.04.07 | Updated to match support available in Quartus® Prime Design Suite version 25.1:
|
2025.01.23 | Added support for the following components, to match support available in Quartus® Prime Design Suite version 24.3.1:
|
2024.04.01 | Updated to match support available in Quartus® Prime Design Suite version 24.1.
|
2023.12.04 | Updated the Reading Device Information from SDM-Based Devices section to match GUI. |
2023.10.02 | Updated to match support available in Quartus® Prime Design Suite version 23.3.
|
2023.06.26 | Updated to match support available in Quartus® Prime Design Suite version 23.2.
|
2023.04.10 |
|
2022.09.26 | Updated to match support available in Quartus® Prime Design Suite version 22.3.
|
2022.05.23 | Updated to match support available in Quartus® Prime Design Suite version 22.1.
|
2021.11.04 | Initial release. |