1G/2.5G/5G/10G Multi-rate Ethernet PHY Intel® Stratix® 10 FPGA IP User Guide

Download PDF
ID 683876
Date 11/15/2021
Public
Document Table of Contents
Document Table of Contents x
1. About the 1G/2.5G/5G/10G Multi-rate Ethernet PHY Intel® FPGA IP Core 2. Getting Started 3. Parameter Settings 4. Functional Description 5. Configuration Registers 6. Interface Signals 7. 1G/2.5G/5G/10G Multi-rate Ethernet PHY Intel® Stratix® 10 FPGA IP User Guide Archives A. Document Revision History for the 1G/2.5G/5G/10G Multi-rate Ethernet PHY Intel® Stratix® 10 FPGA IP User Guide
1. About the 1G/2.5G/5G/10G Multi-rate Ethernet PHY Intel® FPGA IP Core x
1.1. Features 1.2. Device Family Support 1.3. Device Speed Grade Support 1.4. Resource Utilization 1.5. Release Information
2. Getting Started x
2.1. Installing and Licensing Intel® FPGA IP Cores 2.2. Specifying the IP Core Parameters and Options 2.3. Generated File Structure 2.4. Integrating Your IP Core in Your Design
2.1. Installing and Licensing Intel® FPGA IP Cores x
2.1.1. Intel® FPGA IP Evaluation Mode
2.4. Integrating Your IP Core in Your Design x
2.4.1. Pin Assignments 2.4.2. Adding the Transceiver PLL 2.4.3. Adding the Intel® Stratix® 10 Transceiver PHY Reset Controller
4. Functional Description x
4.1. Clocking and Reset Sequence 4.2. Timing Constraints 4.3. Switching Operation Speed
5. Configuration Registers x
5.1. Register Map 5.2. Register Definitions
6. Interface Signals x
6.1. Clock and Reset Signals 6.2. Transceiver Mode and Operating Speed Signals 6.3. Serial Interface Signals 6.4. GMII Signals 6.5. XGMII Signals 6.6. Avalon® -MM Interface Signals 6.7. Transceiver Status and Reconfiguration Signals 6.8. Status Signals
1. About the 1G/2.5G/5G/10G Multi-rate Ethernet PHY Intel® FPGA IP Core
2. Getting Started
3. Parameter Settings
4. Functional Description
5. Configuration Registers
6. Interface Signals
7. 1G/2.5G/5G/10G Multi-rate Ethernet PHY Intel® Stratix® 10 FPGA IP User Guide Archives
A. Document Revision History for the 1G/2.5G/5G/10G Multi-rate Ethernet PHY Intel® Stratix® 10 FPGA IP User Guide

6.7. Transceiver Status and Reconfiguration Signals

Table 22.  Transceiver Status and Reconfiguration Signals
Signal Name Direction Width Description PHY Configurations
rx_is_lockedtodata Output 1 Asserted when the CDR is locked to the RX data. All
tx_cal_busy Output 1 Asserted when TX calibration is in progress.
rx_cal_busy Output 1 Asserted when RX calibration is in progress.
Transceiver reconfiguration signals
reconfig_clk Input 1 Reconfiguration signals connected to the reconfiguration block. The reconfig_clk signal provides the timing reference for this interface. All
reconfig_reset Input 1
reconfig_address Input 11
reconfig_write Input 1
reconfig_read Input 1
reconfig_writedata Input 32
reconfig_readdata Output 32
reconfig_waitrequest Output 1
Related Information
Level Two Title