1.1. Using Provided HDL Templates 1.2. Instantiating IP Cores in HDL 1.3. Inferring Multipliers and DSP Functions 1.4. Inferring Memory Functions from HDL Code 1.5. Register and Latch Coding Guidelines 1.6. General Coding Guidelines 1.7. Designing with Low-Level Primitives 1.8. Cross-Module Referencing (XMR) in HDL Code 1.9. Using force Statements in HDL Code 1.10. Recommended HDL Coding Styles Revision History
18.104.22.168. Use Synchronous Memory Blocks 22.214.171.124. Avoid Unsupported Reset and Control Conditions 126.96.36.199. Check Read-During-Write Behavior 188.8.131.52. Controlling RAM Inference and Implementation 184.108.40.206. Single-Clock Synchronous RAM with Old Data Read-During-Write Behavior 220.127.116.11. Single-Clock Synchronous RAM with New Data Read-During-Write Behavior 18.104.22.168. Simple Dual-Port, Dual-Clock Synchronous RAM 22.214.171.124. True Dual-Port Synchronous RAM 126.96.36.199. Mixed-Width Dual-Port RAM 188.8.131.52. RAM with Byte-Enable Signals 184.108.40.206. Specifying Initial Memory Contents at Power-Up
220.127.116.11. If Performance is Important, Optimize for Speed 18.104.22.168. Use Separate CRC Blocks Instead of Cascaded Stages 22.214.171.124. Use Separate CRC Blocks Instead of Allowing Blocks to Merge 126.96.36.199. Take Advantage of Latency if Available 188.8.131.52. Save Power by Disabling CRC Blocks When Not in Use 184.108.40.206. Initialize the Device with the Synchronous Load (sload) Signal
3.4.1. Apply Complete System-Centric Timing Constraints for the Timing Analyzer 3.4.2. Force the Identification of Synchronization Registers 3.4.3. Set the Synchronizer Data Toggle Rate 3.4.4. Optimize Metastability During Fitting 3.4.5. Increase the Length of Synchronizers to Protect and Optimize 3.4.6. Increase the Number of Stages Used in Synchronizers 3.4.7. Select a Faster Speed Grade Device
220.127.116.11.3. Deleting Design Assistant Waivers
To fully remove (delete) any Design Assistant waivers that are no longer useful, delete the waiver in the Design Assistant Manage Waivers dialog box.
Design Assistant Manage Waivers Dialog Box
- Right-click a rule violation with a waiver, and click Waivers > Manage Waivers.
- In the Design Assistant Manager Waivers dialog box, select the waiver you want to delete under All waivers for rule.
- Click the Delete Waiver button to delete the waiver.
As an alternative to the GUI, you can also create and modify Design Assistant waivers by editing the Design Assistant Waivers File (da_drc.dawf), or by using Tcl commands within an interactive Tcl shell. The da_drc.dawf stores the waiver definitions you specify in the GUI. To avoid unintended results, do not edit the da_drc.dawf file while Compiler processes are running.
Figure 44. Deleting Waiver from Design Waivers File
Did you find the information on this page useful?