GTS Ethernet Hard IP User Guide: Agilex™ 3 FPGAs and SoCs
ID
848477
Date
7/07/2025
Public
1. Overview
2. Install and License the GTS Ethernet Hard IP
3. Configure and Generate Ethernet Hard IP variant
4. Integrate GTS Ethernet Hard IP into Your Application
5. Simulate and Compile (MAC+PCS) Design Example
6. Simulate and Compile (MII PCS Only/PCS66 OTN/PCS66 FlexE) Design Example
7. Simulate and Compile SyncE Design Example
8. Simulate and Compile PTP1588 Design Example
9. Simulate and Compile (Dynamically Reconfigurable Ethernet Mode)
10. Simulate and Compile - Auto-Negotiation and Link Training
11. Troubleshoot and Diagnose Issues
12. Appendix A: Functional Description
13. Appendix B: Configuration Registers
14. Appendix C: Document Revision History for the GTS Ethernet Hard IP User Guide: Agilex 3 FPGAs and SoCs
4.1. Implement Required Clocking
4.2. Implement Required Resets
4.3. Connect the Status Interface
4.4. Connect the MAC Avalon Streaming Client Interface
4.5. Connect the MII PCS Only Client Interface
4.6. Connect the PCS66 Client Interface – FlexE and OTN
4.7. Connect the Precision Time Protocol Interface
4.8. Connect the Ethernet Hard IP Reconfiguration Interface
4.9. Connect the Auto-Negotiation and Link Training
4.10. Connect the Multirate Auto-Negotiation and Link Training
4.11. Connect the Dynamically Reconfigurable Ethernet Mode
4.4.1.1. Drive the Ethernet Packet to the TX MAC Avalon Streaming Client Interface with Disabled Preamble Passthrough
4.4.1.2. Drive the Ethernet Packet on the TX MAC Avalon Streaming Client Interface with Enabled Preamble Passthrough
4.4.1.3. Use i_tx_skip_crc to Control Source Address, PAD, and CRC Insertion
4.4.1.4. Assert the i_tx_error to Invalidate a Packet
4.4.2.1. Receive Ethernet Frame on the RX MAC Avalon Streaming Client Interface with Preamble Passthrough Disabled
4.4.2.2. Receive Ethernet Frame with Preamble Passthrough Enabled
4.4.2.3. Receive Ethernet Frame with Remove CRC bytes Disabled
4.4.2.4. Monitor Status and Errors on the RX MAC Avalon Streaming Client Interface
12.3. PCS, OTN, and FlexE Modes
Each GTS Ethernet Hard IP instance contains a full featured multi-channel PCS layer, which offers a number of interfacing options from the FPGA fabric.
The IP offers the following PCS options:
- PCS—This mode uses the MII interface to transmit and receive Ethernet packets for data rate of 10GE . It consists of:
- PCS—Direct Single Channel with and without FEC
- PCS—Direct Multiple Channel with and without FEC
- OTN and FlexE—This mode uses the PCS66 interface to read and write 66 bit blocks data, from and to the PMA block.