Detailed Attributes of Function Events
This dialog box provides you with detailed information about function events.
Use the following entries of this dialog box:
Select This: |
To Do This: |
|---|---|
Name |
Specify the name of the selected function. If it represents a Function
Group, then it is prefixed with the Group name. |
Process Group |
Specify the Process, Function or Group in which the selected event occurred |
Duration | Show the time spent in a given Function/Group. For coarser resolutions (Count ≥ 1), the value does not reflect the
actual time spent in this function but the length of the time interval
over which several function events were merged. |
Start Time | Show the time when the event entered the Function/Group. For coarser resolutions (Count ≥ 1) the value represents the start of the
time interval over which several function events where merged. |
End Time | Show the time when the event left the Function/Group. On coarser resolutions (Count ≥ 1) the value represents the end of time
the interval over which several function events where merged. |
Total #Calls | Give the total number of function calls. It contains all calls covered by
the function in the given time interval, including calls to functions
other than the function clicked. If the column Total #Calls shows a value greater than one, the event was
created by merging several atomic events. Each entry representing a merged event shows a View, which focuses on the
data that went into this entry using the drill down button shown next to
the entry. This is called a Detail View; it is a full blown View without
restrictions. In the dialog box below the list is a check box that allows
you to filter out the other event categories in the Detail View to be
opened. |
Sometimes a Function starts before and/or ends after the displayed time interval.
In these possible cases, you may see in the Details dialog a less
<
character preceding the numeric value listed under the column Start Time, and a
greater >
character preceding the numeric values listed under the columns
End Time
and Duration
. These numeric values are the boundaries of
the current zoom interval.