Visible to Intel only — GUID: cns1712564379167
Ixiasoft
1. About the MIPI CSI-2 Intel® FPGA IP
2. MIPI CSI-2 Intel® FPGA IP Interface Overview
3. MIPI CSI-2 Intel® FPGA IP Parameters
4. Designing with the MIPI CSI-2 Intel® FPGA IP
5. MIPI CSI-2 Intel® FPGA IP Block Descriptions
6. Registers
7. Document Revision History for MIPI CSI-2 Intel® FPGA IP User Guide
2.3.1. Receiver PHY Protocol Interface (PPI) Signals
2.3.2. Avalon® Memory-Mapped Interface Control Interface Signals
2.3.3. Receiver AXI4-Streaming Output Video Interface Signals
2.3.4. Receiver AXI4-Stream Output Passthrough Interface
2.3.5. Transmitter PHY-Protocol Interface (PPI) Signals
2.3.6. Transmitter AXI4-Stream Input Video Interface Signals
2.3.7. Transmitter AXI4-Stream Input Passthrough Interface
Visible to Intel only — GUID: cns1712564379167
Ixiasoft
4.3.3. MIPI CSI-2 Transmitter Clock Requirements
The CSI-2 Transmitter axi4_clk frequency should be selected such that the input video data rate achieved is the same or greater than the desired overall video data rate on the external MIPI D-PHY interface. If this is not achieved, then the data throughput will not meet requirements.
Equation 6. Derivation of the CSI-2 Transmitter axi4_clk Minimum Rate
Intel recommends that you allow at least 10% buffer above the minimum clock rate calculated for this clock.
Video Data Type | Line Rate (Mbps) | PPI_Bus Width (Bits) | tx_word_clk_hs_dX (MHz) | Lanes | Pixels in Parallel | Bits per Pixel | axi4s_clk (MHz) |
---|---|---|---|---|---|---|---|
RAW10 | 800 | 16 | 50 | 2 | 1 | 10 | >160 |
RGB888 | 1500 | 16 | 93.75 | 4 | 2 | 24 | >125 |
Related Information