Visible to Intel only — GUID: wnh1712564314082
Ixiasoft
1. About the MIPI CSI-2 Intel® FPGA IP
2. MIPI CSI-2 Intel® FPGA IP Interface Overview
3. MIPI CSI-2 Intel® FPGA IP Parameters
4. Designing with the MIPI CSI-2 Intel® FPGA IP
5. MIPI CSI-2 Intel® FPGA IP Block Descriptions
6. Registers
7. Document Revision History for MIPI CSI-2 Intel® FPGA IP User Guide
2.3.1. Receiver PHY Protocol Interface (PPI) Signals
2.3.2. Avalon® Memory-Mapped Interface Control Interface Signals
2.3.3. Receiver AXI4-Streaming Output Video Interface Signals
2.3.4. Receiver AXI4-Stream Output Passthrough Interface
2.3.5. Transmitter PHY-Protocol Interface (PPI) Signals
2.3.6. Transmitter AXI4-Stream Input Video Interface Signals
2.3.7. Transmitter AXI4-Stream Input Passthrough Interface
Visible to Intel only — GUID: wnh1712564314082
Ixiasoft
4.3.2. MIPI CSI-2 Receiver Clock Requirements
The CSI-2 Receiver axi4_clk frequency must ensure that the output video data rate is the same or greater than the peak burst data rate on the external MIPI D-PHY interface. If this is not achieved, then data loss will occur.
Equation 5. Derivation of the CSI-2 Receiver axi4_clk Minimum Rate
Intel recommends that you allow at least 10% buffer above the minimum clock rate calculated for this clock.
Video Data Type | Line Rate (Mbps) | PPI_Bus Width (Bits) | rx_word_clk_hs_dX (MHz) | Lanes | Pixels in Parallel | Bits per Pixel | axi4s_clk (MHz) |
---|---|---|---|---|---|---|---|
RAW10 | 800 | 16 | 50 | 2 | 1 | 10 | >160 |
RAW16 | 2500 | 16 | 156.25 | 4 | 4 | 16 | >160 |
RGB888 | 1500 | 16 | 93.75 | 4 | 2 | 24 | >125 |
YUV422 8-bit | 1000 | 16 | 62.5 | 8 | 2 | 16 | >250 |