E-tile Hard IP Intel® Stratix® 10 Design Examples User Guide: Ethernet, CPRI PHY, and Dynamic Reconfiguration

ID 683578
Date 3/06/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

4.1.4. Compiling and Configuring the Design Example in Hardware

To compile the hardware design example and configure it on your Intel® Stratix® 10 device, follow these steps:

  1. Ensure hardware design example generation is complete.
  2. In the Intel® Quartus® Prime Pro Edition software, open the Intel® Quartus® Prime project <design_example_dir>/hardware_test_design/alt_ehipc3.qpf.
  3. On the Processing menu, click Start Compilation.
  4. After successful compilation, a .sof file is available in <design_example_dir>/hardware_test_design directory. Follow these steps to program the hardware design example on the Intel® Stratix® 10 device:
    1. On the Tools menu, click Programmer.
    2. In the Programmer, click Hardware Setup.
    3. Select a programming device.
    4. Select and add the Stratix 10 E-Tile TX Transceiver Signal Integrity Development Kit to which your Intel® Quartus® Prime Pro Edition session can connect.
    5. Ensure that Mode is set to JTAG.
    6. Select the device and click Add Device. The Programmer displays a block diagram of the connections between the devices on your board.
    7. In the row with your .sof, check the box for the .sof.
    8. Check the box in the Program/Configure column.
    9. Click Start.