2.1. Starting the Flash Programmer GUI
2.2. Specifying your Flash Programmer Settings
2.3. Working with Flash Programmer Settings Files
2.4. Setting the Hardware Connection
2.5. Checking System ID and System Timestamp
2.6. Generating Flash Files and Programming Flash Memory
2.7. Document Revision History for Using the Flash Programmer GUI
B.1. Overview
B.2. Start Button Grayed Out in the Flash Programmer GUI
B.3. 'No Nios® II Processors Available' Error
B.4. 'No CFI Table Found' Error
B.5. 'No EPCS Registers Found' Error
B.6. 'System Does Not Have Any Flash Memory' Error
B.7. 'Reading System ID at Address 0x<address>: FAIL' Error
B.8. 'Base Address Not Aligned on Size of Device' Error
B.9. Document Revision History for Troubleshooting
1.1. Prerequisites
This user guide assumes that you are familiar with the Nios® II hardware and software development flow. You need to be familiar with the contents of the following documents:
- Nios® II Hardware Development Tutorial
- "Getting Started with the Graphical User Interface" chapter of the Nios® II Gen2 Software Developer's Handbook.
If you use the Nios® II Flash Programmer to program FPGA configuration data to flash memory, you also must understand the configuration method used on the board.
For more information, refer to AN346:Using the Nios® II Configuration Controller Reference Designs, or to the reference manual for your specific development board.