Stratix V Avalon-ST Interface for PCIe Solutions: User Guide

ID 683093
Date 5/03/2019
Document Table of Contents

13.2.1. Enabling Autonomous Mode

These steps specify autonomous mode in the Quartus Prime software.
  1. On the Quartus Prime Assignments menu, select Device > Device and Pin Options.
  2. Under Category > General turn on Enable autonomous PCIe HIP mode.
    The Enable autonomous PCIe HIP mode option has an effect if your design has the following two characteristics:
    • You are using the Flash device or Ethernet controller, instead of the PCIe link to load the core image.
    • You have not turned on Enable Configuration via the PCIe link in the Hard IP for PCI Express GUI.

Did you find the information on this page useful?

Characters remaining:

Feedback Message