Nios® V Processor Reference Manual

Download PDF
ID 683632
Date 8/01/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
Document Table of Contents x
1. Overview 2. Nios® V/m Processor 3. Nios V Processor Reference Manual Archives 4. Document Revision History for the Nios® V Processor Reference Manual
2. Nios® V/m Processor x
2.1. Processor Performance Benchmarks 2.2. Processor Pipeline 2.3. Processor Architecture 2.4. Programming Model 2.5. Core Implementation
2.3. Processor Architecture x
2.3.1. General-Purpose Register File 2.3.2. Arithmetic Logic Unit 2.3.3. Reset and Debug Signals 2.3.4. Control and Status Registers 2.3.5. Exception Controller 2.3.6. Interrupt Controller 2.3.7. Memory and I/O Organization 2.3.8. RISC-V based Debug Module
2.3.6. Interrupt Controller x
2.3.6.1. Timer and Software Interrupt Module
2.3.7. Memory and I/O Organization x
2.3.7.1. Instruction and Data Buses
2.3.7.1. Instruction and Data Buses x
2.3.7.1.1. Instruction Manager Port 2.3.7.1.2. Data Manager Port 2.3.7.1.3. Address Map
2.3.8. RISC-V based Debug Module x
2.3.8.1. Debug Mode 2.3.8.2. Halt from Debug Module 2.3.8.3. Trigger 2.3.8.4. Abstract Commands in Debug Mode 2.3.8.5. Hardware/Software Interface
2.4. Programming Model x
2.4.1. Privilege Levels 2.4.2. Control and Status Registers (CSR) Mapping
2.4.1. Privilege Levels x
2.4.1.1. Machine Mode (M-mode) 2.4.1.2. Debug Mode (D-mode)
2.4.2. Control and Status Registers (CSR) Mapping x
2.4.2.1. Control and Status Register Field
2.5. Core Implementation x
2.5.1. Instruction Set Reference
1. Overview
2. Nios® V/m Processor
3. Nios V Processor Reference Manual Archives
4. Document Revision History for the Nios® V Processor Reference Manual

2.3.6.1. Timer and Software Interrupt Module

The timer and software interrupt hosts the following registers:
  • Machine Time (mtime) and Machine Time Compare (mtimecmp) registers for timer interrupt.
  • Machine Software Interrupt-pending (msip) field for the software interrupt.

The value of mtime increments after every clock cycle. When the value of mtime is greater or equal to the value of mtimecmp, the timer posts the interrupt.

Level Two Title