AN 951: Intel® Stratix® 10 I/O Limited FPGA Design Guidelines

Download PDF
ID 683607
Date 8/24/2021
Public
Document Table of Contents
Document Table of Contents x
1. Introduction 2. Overview 3. Intel® Quartus® Prime Software Guidelines 4. Device Guidelines 5. Document Revision History for AN 951: Intel® Stratix® 10 I/O Limited FPGA Design Guidelines
2. Overview x
2.1. Available Device Options and Ordering Part Numbers
3. Intel® Quartus® Prime Software Guidelines x
3.1. Design Migration 3.2. Intel® Quartus® Prime Software Patch Compatibility 3.3. Related Intel® Quartus® Prime Software Error Messages
4. Device Guidelines x
4.1. Device Configuration Guidelines 4.2. GPIO and LVDS Guidelines 4.3. Transceiver Guidelines 4.4. Error Message for Design Exceeding Maximum Transceiver Bandwidth
4.2. GPIO and LVDS Guidelines x
4.2.1. I/O Resource Comparison Between Standard OPN and IOL OPN Devices 4.2.2. Design Migration 4.2.3. Error Message for > 700 Pins Utilization
4.3. Transceiver Guidelines x
4.3.1. Transceiver Bandwidth Calculation
1. Introduction
2. Overview
3. Intel® Quartus® Prime Software Guidelines
4. Device Guidelines
5. Document Revision History for AN 951: Intel® Stratix® 10 I/O Limited FPGA Design Guidelines

3.3. Related Intel® Quartus® Prime Software Error Messages

When compiling designs targeting Intel® Stratix® 10 I/O Limited FPGAs, you might encounter compilation error messages as shown below.

Table 3.  Related Intel® Quartus® Prime Software Error Messages
Intel® Quartus® Prime Software Error Message Reference
This design uses a device that is restricted to a maximum of 700 user-IOs. Currently, <I/O pin count> are being used!” Error Message for > 700 Pins Utilization
The current device <device OPN>’s data-rate cannot exceed 499Gbps. The design’s TX data-rate is <TX cumulative data-rate>, and RX data-rate is <RX cumulative data-rate>. Error Message for Design Exceeding Maximum Transceiver Bandwidth
Level Two Title